3. INSTALL BUS BAR.

TM-9-6150-226-13 Generator Set Skid Mounted Tactical Quiet 60 Kw 50/80 and 400 Hz MEP-806B (50/60 Hz) MEP-816B (400Hz) Manual
Page Navigation
139

TM 9-6150-226-13 4-17 CIRCUIT BREAKER ASSEMBLY AND BUS BAR. (cont) c. d. e. f. 9. 3. INSTALL BUS BAR. NOTE When removing ground bus bar, disconnect and remove ground strap connecting bus bar to enclosure. Tag and disconnect wiring (8) from bus bar terminals (9). Remove nut (10) securing bus bar (9) to feeder/distri- bution center. Remove bus bar. Tag and disconnect wiring (11 ) from three phase bus bars (12). Remove screws (13) securing bus bars. Remove bus bars. Tag and disconnect wiring (14) from ground (15) and neutral (16) bus bars. Remove screws (17), nuts (18) and washers (19) securing bus bars. Remove bus bars. Remove screw (20), nut (18), and washer (19) securing ground strap. a. b. c. NOTE If you have PDISE equip ment, follow instructions in paragraph 3c, d, e and f. Install bus bar (9) and secure with nut (10). Solder dip or solder gun wire ends, not to exceed .025 inches, using Kester Solder MIL Spec No. QQ-S-571 (Sn 60 Pb 40). Refer to tags and connect wiring (8) to bus bar terminals (9). Remove tags and torque terminals in accordance with table G-1. 4-50 Change 1

Privacy Statement
Press Release
Contact