 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-364-20-1
Allow engine to cool before performing trouble-
shooting maintenance. If necessary use
insulated pads and gloves. Hot engine
components will burn and cause injury to
personnel.
Remove all jewelry such as rings, dog tags,
bracelets, etc. If jewelry or tools contact
positive electrical circuits, a direct short
may result. Damage to equipment, injury or
death to personnel may occur.
Use jumperwire only between terminals indicated.
Failure to comply may result in damage to DDEC
components or wiring.
RESISTANCE TEST
(1) Place jumperwire between terminals
J and K at DDL connector MC13.
(2) Are there 5 ohms or less present
between wires 901 and 900 at vehicle
harness connector MC18, terminals
C2 and C1.
(a) If there are more than 5 ohms
present, remove jumperwire and
repair wires 901 and/or 900
(see schematic Fig 2-1) or notify
DS Maintenance.
(b) If there are less than 5 ohms
present, remove jumperwire and
go to Step 3 of this Fault.
RESISTANCE TEST
Are there 5 ohms or less present between
wires 901 and 900 at vehicle harness
connector MC18, terminals C2 and C1.
(1) If there are more than 5 ohms
present, repair wires 901 and/or
900 (see schematic Fig 2-1) or
notify DS Maintenance.
(2) If there are less than 5 ohms
present, go to Step 4 of this Fault.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals